Clubs

[Kadiddle]

Everything is about 20" of white around here today. I hope the stuff stays where it is, but the wind will toss it around before the morning Such is life north of the Adirondacks.
Carve On,
Kadiddle...

[Kadiddle]

Outstanding! Thanks for the show and tell of the progress.
Carve On,
Kadiddle

[Kadiddle]

Eddie, I also have the 395. Separate purchased flex shaft and foot control. Just a suggestion, check the motor brushes, they may need to be replaced. Ace hardware, True Value, hardware stores carry Dremel products around here, not sure if you have those down there, they have web sites also. Hope this...

[Kadiddle]

Would the chamfer tool be a 82 degree countersink for metal work? Good idea.
Carve On,
Kadiddle

[Kadiddle]

Hope it has a horn for back- up and fog.
Carve On,
Kadiddle

[Kadiddle]

Landscapes in relief, by Lora Irish came to mind first. Dylan Goodson also. Good luck.
Carve On,
Kadiddle

[Kadiddle]

Agree with all of the above and would like add the vibrant colors look really nice. Thanks for showing.
Carve On,
Kadiddle

[Kadiddle]

Nice starter carving. Could also make nice pins by carving only one side. Nice paint job.
Carve On,
Kadiddle

[Kadiddle]

Good save Eddy. You put lipstick on it and sure enough, its still a pig.
Carve On,
Kadiddle

[Kadiddle]

Thanks Bill and Mike. They both were the help I needed.
Carve On,
Kadiddle

[Kadiddle]

Welcome back Larry. Hope all is going good for you. Speedy recovery.
Carve On,
Kadiddle

[Kadiddle]

Yes, and hang a sign on it that states 'Blade and Belt tension is Off'. It takes the pressure off the bearings as well. Done at the end of the day.
Carve On,
Kadiddle

[Kadiddle]

Does anyone know of carving clubs in southern California, San Diego up to L.A. area. There does not seem to have a club listed in the club choice of the forum. Thanks as I have a family member in that area I will be visiting in the future and would like to have a place to check out.
Carve On,...